HP 10500 SERIES Configuration Manual page 299

[Hub-PE-Vlan-interface5] mpls ldp
[Hub-PE-Vlan-interface5] quit
After the configuration, LDP sessions are established between Spoke-PE 1 and Hub-PE, and
between Spoke-PE 2 and Hub-PE. Issue the display mpls ldp session command. The output shows
that the session status is Operational. Issue the display mpls ldp lsp command.
Takes Spoke-PE 1 as an example:
[Spoke-PE1] display mpls ldp session
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID
---------------------------------------------------------------
2.2.2.9:0
---------------------------------------------------------------
LAM : Label Advertisement Mode
[Spoke-PE1] display mpls ldp lsp
------------------------------------------------------------------
SN DestAddress/Mask
------------------------------------------------------------------
1 1.1.1.9/32
2 2.2.2.9/32
3 3.3.3.9/32
------------------------------------------------------------------
A '*' before an LSP means the LSP is not established
A '*' before a Label means the USCB or DSCB is stale
Configure VPN instances on the spoke-PEs and the hub-PE to allow CEs to access the PEs:
3.
# Configure Spoke-PE 1.
[Spoke-PE1] ip vpn-instance vpn1
[Spoke-PE1-vpn-instance-vpn1] route-distinguisher 100:1
[Spoke-PE1-vpn-instance-vpn1] vpn-target 111:1 import-extcommunity
[Spoke-PE1-vpn-instance-vpn1] vpn-target 222:2 export-extcommunity
[Spoke-PE1-vpn-instance-vpn1] quit
[Spoke-PE1] interface vlan-interface 2
[Spoke-PE1-Vlan-interface2] ip binding vpn-instance vpn1
[Spoke-PE1-Vlan-interface2] ip address 10.1.1.2 24
[Spoke-PE1-Vlan-interface2] quit
# Configure the Spoke-PE 2.
[Spoke-PE2] ip vpn-instance vpn1
[Spoke-PE2-vpn-instance-vpn1] route-distinguisher 100:2
[Spoke-PE2-vpn-instance-vpn1] vpn-target 111:1 import-extcommunity
[Spoke-PE2-vpn-instance-vpn1] vpn-target 222:2 export-extcommunity
[Spoke-PE2-vpn-instance-vpn1] quit
[Spoke-PE2] interface vlan-interface 3
[Spoke-PE2-Vlan-interface3] ip binding vpn-instance vpn1
[Spoke-PE2-Vlan-interface3] ip address 10.2.1.2 24
[Spoke-PE2-Vlan-interface3] quit
LDP Session(s) in Public Network
Status LAM
Operational DU
LDP LSP Information
In/OutLabel
3/NULL
NULL/3
NULL/1024
291
SsnRole FT MD5
Passive Off Off
FT : Fault Tolerance
Next-Hop In/Out-Interface
127.0.0.1 -------/InLoop0
172.1.1.2 -------/Vlan-interface4
172.1.1.2 -------/Vlan-interface4
KA-Sent/Rcv
5/5