HP 10500 SERIES Configuration Manual page 25

Step
3. Disable routing loop
detection.
4. Configure the OSPF
domain ID.
5. Redistribute the VPN
routes.
6. Configure filtering of
redistributed routes.
7. Configure the default
parameters for
redistributed routes (cost,
route number, tag, and
type).
8. Create an OSPF area
and enter OSPF area
view.
9. Enable OSPF on the
interface attached to the
specified network in the
area.
Configuring IS-IS between MCE and PE
Step
1. Enter system view.
2. Create an IS-IS process
for a VPN instance and
enter IS-IS view.
3. Configure a network
entity title.
4. Redistribute the VPN
routes.
Command
vpn-instance-capability simple
domain-id domain-id
[ secondary ]
import-route protocol [ process-id
| allow-ibgp ] [ cost cost | type
type | tag tag | route-policy
route-policy-name ] *
filter-policy { acl-number |
ip-prefix ip-prefix-name } export
[ protocol [ process-id ] ]
default { cost cost | limit limit | tag
tag | type type } *
area area-id
network ip-address
wildcard-mask
Command
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
network-entity net
import-route { isis [ process-id ] | ospf
[ process-id ] | rip [ process-id ] | bgp
[ allow-ibgp ] | direct | static } [ cost cost
| cost-type { external | internal } |
[ level-1 | level-1-2 | level-2 ] |
route-policy route-policy-name | tag
tag ] *
17
Remarks
Disabled by default.
You must disable routing loop detection
for a VPN OSPF process on the MCE.
Otherwise, the MCE cannot receive
OSPF routes from the PE.
Optional.
0 by default.
By default, no route of any other routing
protocol is redistributed into OSPF.
Optional.
By default, OSPF does not filter
redistributed routes.
Optional.
The default cost is 1, the default
maximum number of routes redistributed
per time is 1000, the default tag is 1,
and default type of redistributed routes is
Type-2.
By default, no OSPF area is created.
By default, an interface neither belongs
to any area nor runs OSPF.
Remarks
N/A
N/A
Not configured by default.
Optional.
By default, IS-IS does not
redistribute routes of any other
routing protocol.
If you do not specify the route level
in the command, the command
redistributes routes to the level-2
routing table by default.