HP 10500 SERIES Configuration Manual page 321

Hide thumbs Also See for 10500 SERIES:
Table of Contents

Advertisement

[PE1-LoopBack0] isis enable 1
[PE1-LoopBack0] quit
[PE1] interface vlan-interface 12
[PE1-Vlan-interface12] ip address 30.1.1.1 24
[PE1-Vlan-interface12] isis enable 1
[PE1-Vlan-interface12] mpls
[PE1-Vlan-interface12] mpls ldp
[PE1-Vlan-interface2] mpls ldp transport-address interface
[PE1-Vlan-interface2] quit
[PE1] bgp 100
[PE1-bgp] peer 4.4.4.9 as-number 100
[PE1-bgp] peer 4.4.4.9 connect-interface loopback 0
[PE1-bgp] ipv4-family vpnv4
[PE1-bgp-af-vpnv4] peer 4.4.4.9 enable
[PE1-bgp-af-vpnv4] quit
[PE1-bgp] quit
# Configure PE 2 in a similar way to configuring PE 1. (Details not shown.)
After completing the configurations, issue the display mpls ldp session command on PE 1 or PE 2.
The output shows that the LDP session has been established successfully. Issue the display bgp peer
command. The output shows that the BGP peer relationship has been established and has reached
Established state. Issue the display isis peer command. The output shows that the IS-IS neighbor
relationship has been set up. Take PE 1 as an example:
[PE1] display mpls ldp session
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID
----------------------------------------------------------------
4.4.4.9:0
----------------------------------------------------------------
LAM : Label Advertisement Mode
[PE1] display bgp peer
BGP local router ID : 3.3.3.9
Local AS number : 100
Total number of peers : 1
Peer
4.4.4.9
[PE1] display isis peer
System Id
0000.0000.0005 Vlan-interface2
Configure the customer carrier network: start IS-IS as the IGP and enable LDP between PE 3 and CE
2.
1, and between PE 4 and CE 2:
# Configure PE 3.
<PE3> system-view
[PE3] interface loopback 0
[PE3-LoopBack0] ip address 1.1.1.9 32
LDP Session(s) in Public Network
Status
LAM
Operational
DU
AS
MsgRcvd
MsgSent
100
162
145
Peer information for ISIS(1)
----------------------------
Interface
Circuit Id
001
313
SsnRole
FT
MD5
Active
Off
Off
FT
: Fault Tolerance
Peers in established state : 1
OutQ
PrefRcv
Up/Down
0
0
02:12:47 Established
State HoldTime
Up
29s
KA-Sent/Rcv
378/378
State
Type
PRI
L1L2
--

Advertisement

Table of Contents
loading

Table of Contents