HP 10500 SERIES Configuration Manual page 43

# Advertise the address of tunnel interface Tunnel 1.
[MCE1-ospf-2-area-0.0.0.0] network 10.1.2.1 0.0.0.255
# Configure RIP process 1 for VPN instance vpn2.
[MCE1] rip 1 vpn-instance vpn2
[MCE1-rip-1]
# Advertise the IP address of VLAN-interface 11.
[MCE1-rip-1] network 10.214.20.1
# Redistribute routes learned by OSPF process 2 to RIP process 1.
[MCE1-rip-1] import-route ospf 2
[MCE1-rip-1] quit
# Redistribute routes learned by RIP process 1 to OSPF process 2.
[MCE1] ospf 2
[MCE1-ospf-2] import-route rip 1
# On MCE 2, configure OSPF process 2 for VPN instance vpn2, and configure OSPF to support
MCE. Be sure to configure the same OSPF area as that configured at site 2 of VPN 2, area 0 in this
example.
[MCE2] ospf 2 vpn-instance vpn2 router-id 172.16.2.1
[MCE2-ospf-2] vpn-instance-capability simple
[MCE2-ospf-2] area 0
[MCE2-ospf-2-area-0.0.0.0]
# Advertise the addresses of interfaces VLAN-interface 21 and Tunnel 1 on MCE 2.
[MCE2-ospf-2-area-0.0.0.0] network 10.214.40.1 0.0.0.255
[MCE2-ospf-2-area-0.0.0.0] network 10.1.2.2 0.0.0.255
35