HP 10500 SERIES Configuration Manual page 97

Local Discr : 130
Tunnel ID : ---
Session State : Up
Session Role : Passive
FEC : 21.1.1.0/24
Local Discr : 129
Tunnel ID : 0x6040000
Session State : Up
Session Role : Active
Total Session Num: 2
The output shows that two BFD sessions have been established between Switch A and Switch C:
one for testing the connectivity of the LSP Switch A-Switch B-Switch C, and the other for testing the
connectivity of the LSP Switch C-Switch B-Switch A.
# Use the display bfd session verbose command to view detailed information about BFD sessions:
[SwitchA] display bfd session verbose
Total session number: 2
IPv4 session working under Ctrl mode:
Local Discr: 129
Source IP: 1.1.1.9
Session State: Up
Min Trans Inter: 400ms
Min Recv Inter: 400ms
Running Up for: 00:15:52
Connect Type: Indirect
Protocol: MFW/LSPV
Diag Info: No Diagnostic
Local Discr: 130
Source IP: 1.1.1.9
Session State: Up
Min Trans Inter: 400ms
Min Recv Inter: 400ms
Running Up for: 00:15:44
Connect Type: Indirect
Protocol: MFW/LSPV
Diag Info: No Diagnostic
Remote Discr : 130
NextHop
Source IP
Type
Remote Discr : 129
NextHop
Source IP
Up session number: 2
Remote Discr: 129
Destination IP: 127.0.0.1
Interface: LoopBack0
Act Trans Inter: 400ms
Act Detect Inter: 2000ms
Auth mode: None
Board Num: 6
Remote Discr: 130
Destination IP: 3.3.3.9
Interface: LoopBack0
Act Trans Inter: 400ms
Act Detect Inter: 2000ms
Auth mode: None
Board Num: 7
89
: ---
: 3.3.3.9
: LSP
: 10.1.1.2
: 1.1.1.9
Init mode: Active