HP 10500 SERIES Configuration Manual page 361

Step
1. Enter system view.
2. Configure an IPv6 static
route for a VPN instance.
Configuring RIPng between PE and CE
A RIPng process belongs to the public network or a single VPN instance. If you create a RIPng process
without binding it to a VPN instance, the process belongs to the public network.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
To configure RIPng between PE and CE:
Step
1. Enter system view.
2. Create a RIPng process for a
VPN instance and enter RIPng
view.
3. Return to system view.
4. Enter interface view.
5. Enable RIPng on the interface.
Configuring OSPFv3 between PE and CE
An OSPFv3 process belongs to the public network or a single VPN instance. If you create an OSPF
process without binding it to a VPN instance, the process belongs to the public network.
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
To configure OSPFv3 between PE and CE:
Step
1. Enter system view.
2. Create an OSPFv3 process for
a VPN instance and enter the
OSPFv3 view.
3. Set the router ID.
4. Return to system view.
Command
system-view
•
ipv6 route-static ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | next-hop-address |
vpn-instance d-vpn-instance-name
nexthop-address } [ preference preference-value ]
•
ipv6 route-static vpn-instance
s-vpn-instance-name&<1-6> ipv6-address
prefix-length { interface-type interface-number
[ next-hop-address ] | nexthop-address [ public ]
| vpn-instance d-vpn-instance-name
nexthop-address } [ preference preference-value ]
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
quit
interface interface-type
interface-number
ripng process-id enable
Command
system-view
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
router-id router-id
quit
353
Remarks
N/A
Use either command
as needed.
Perform this
configuration on PEs.
On CEs, configure
normal IPv6 static
routes.
For information about
IPv6 static routing, see
Layer 3—IP Routing
Configuration Guide.
Remarks
N/A
Perform this configuration on PEs.
On CEs, create a normal RIPng
process.
N/A
N/A
By default, RIPng is disabled on an
interface.
Remarks
N/A
Perform this configuration on PEs.
On CEs, create a normal OSPF
process.
N/A
N/A