HP 10500 SERIES Configuration Manual page 234

[PE2] interface gigabitEthernet 1/0/1
[PE2-GigabitEthernet1/0/1] port access vlan 10
[PE2-GigabitEthernet1/0/1] service-instance 1000
[PE2-GigabitEthernet1/0/1-srv1000] encapsulation s-vid 10
[PE2-GigabitEthernet1/0/1-srv1000] xconnect peer 192.2.2.2 pw-id 1000
[PE2-GigabitEthernet1/0/1-srv1000] quit
[PE2-GigabitEthernet1/0/1] quit
On CE 2, configure an IP address for interface VLAN-interface 10 connected to PE 2.
5.
<Sysname> system-view
[Sysname] sysname CE2
[CE2] interface vlan-interface 10
[CE2-Vlan-interface10] ip address 100.1.1.2 24
Verify your configuration:
6.
# Display VC information on PE 1.
[PE1] display mpls l2vc
Total ldp vc : 1
Transport Client
VC ID Intf
1000 GE1/0/1
The output shows that a VC has been established.
# Display VC information on PE 2. The output shows that a VC has been established.
[PE2] display mpls l2vc
Total ldp vc : 1
Transport Client
VC ID Intf
1000 GE1/0/1
# Ping CE 2 from CE 1. The output shows that CE 1 and CE 2 can ping each other.
[CE1] ping 100.1.1.2
PING 100.1.1.2: 56
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=90 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=77 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=34 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=46 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=94 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 34/68/94 ms
1 up 0 down
Service
ID
1000
1 up 0 down
Service
ID
1000
data bytes, press CTRL_C to break
226
0 blocked
VC Local
State VC Label
up 8193
0 blocked
VC Local
State VC Label
up 8192
Remote
VC Label
8192
Remote
VC Label
8193