Table of Contents
Advertisement
4.
Secure the left and right sides of the slide rail assembly (for the rear side of the rack), with two screws (A).
NOTES:
Make sure that the frame tips on the slide rail assembly are squarely aligned with the
rectangular hole frames of the rack and that the four screw holes of the rail can be seen
through the mating rectangular holes of the rack.
Check that the slide rail assembly is level.
5.
Install the other slide rail assembly on the opposite side of the rack as described in steps 2 to 4 above.
NOTE:
Make sure that the slide rail assembly is installed at the same level than the slide
rail assembly installed first.
3-10
Advertisement
Table of Contents
