Table of Contents
Advertisement
(4) Click on [Close].
(5)
Pull out the server from the rack (without powering off).
(6)
Remove the top cover and locate the board to be removed.
NOTE:
Confirm that the PCI Slot Power LED of the target PCI slot is off.
To stop the device driver using the PCI hot-plug switch:
(1)
Pull out the server from the rack (without powering off).
(2)
Remove the top cover and identify the PCI board to remove.
(3)
Press the PCI hot-plug switch on the slot from which the PCI board is to be removed.
NOTE:
Confirm that the PCI Slot Power LED of the target PCI slot is off.
2.
Disconnect all the cables from the PCI board.
3.
Push the tab to unlock it, slowly open the tab, and remove the PCI board.
IMPORTANT:
could damage the tab.
Tab
Do not open the retention tab to an angle of 90 degrees or more. Doing so
9-33
Advertisement
Table of Contents
