Table of Contents
Advertisement
Starting the SETUP Utility
To run the SETUP utility, perform the following procedures:
1.
Turn on the power of the server.
A full-screen logo appears on the screen (the POST screen may appear instead, depending on the
corresponding BIOS setting).
After a while, one of the following messages appears at the bottom of the screen.
Pattern 1:
Press <F2> to enter SETUP or <F12> to Network
Pattern 2:
Press <F1> to resume, <F2> to enter Setup, <F12> to Network
* The displayed message varies depending on the device status.
2.
Press F2 to start the SETUP utility and display its Main menu.
If you have previously set a password with the SETUP utility, the password entry screen appears. Enter the
password.
Up to three password entries will be accepted. If you fail to enter the password correctly for three consecutive
times, the server halts. (You can no longer proceed.) Power off the server.
NOTE:
The server is provided with two levels of password: Supervisor and User. With the
Supervisor password, you can view and change all system parameters. With the User
password, system parameters available for viewing and changing are limited.
4-2
Advertisement
Table of Contents
