Table of Contents
Advertisement
3.
Define the position of the slide rail assembly so that the bottom of the rail bracket is located at the lower
position of the server.
IMPORTANT:
NOTES:
Check the direction of the slide rail assembly.
– Make the bracket face the outside of the rack.
– The slide rail has different shapes in its left and right side. Refer to the stamp on the
rail (Front → L / Front → R).
The front and rear supports of the rack have rectangular holes for screw fastening. For
the NEC rack, round stamps are provided in 1U. As shown in the figure, a stamp must
be positioned at the tip of slide rail assembly (lower side).
The rail bracket is 3U high.
Make sure that the fingers are locked in the rectangular holes.
If the slide rail is inclined during installation, inner fails may protrude.
3-9
Make sure that the
fingers are locked in
the rectangular holes.
Stamp (located at the
lower right position of
slide rail assembly)
Advertisement
Table of Contents
