Table of Contents
Advertisement
Installation
Follow the steps below to install the processor.
IMPORTANT:
The processor is extremely sensitive to static electricity. Make sure to touch the metal
frame of the server to discharge static electricity from your body before handling the
processor. Do not touch the processor pins with your fingers or place the processor
directly on the desk. For more information on static electricity, refer to the "Anti-static
Measures" section.
When using the server with only one processor, it must be installed in the Processor #1
slot.
Install processors in the ascending order of the processor slot numbers (see figure on the
previous page).
To maintain the cooling effect in the server, cover the empty slots of the processor with
a dummy cover.
1.
See the section "Preparing for Installation and Removal" described earlier.
2.
Unlock the front bezel using the security key, and remove the front bezel.
3.
Remove the cables from the front panel, and put them outside the server.
4.
If an optional 5-inch device is installed, disconnect the cable from the device, and pull out the 5-inch device
toward you.
5.
Unlatch the hooks of the CPU protection cover.
6.
Remove the CPU protection cover.
9-54
Advertisement
Table of Contents
