Table of Contents
Advertisement
INSTALLING Windows Server 2003
Preparations for Installation
EXPRESSBUILDER DVD
Microsoft Windows Server 2003 Standard Edition (CD-ROM) / Microsoft Windows Server 2003 Enterprise
Edition (CD-ROM), Microsoft Windows Server 2003 R2 Standard Edition (CD-ROM) / Microsoft Windows
Server 2003 R2 Enterprise Edition (CD-ROM)
User's Guide
Getting Started
Windows Server 2003 OEM-Disk for EXPRESSBUILDER
Windows Server 2003 Service Pack (CD-ROM)
Creating "Windows Server 2003 OEM-Disk for EXPRESSBUILDER"
Before installing, create Windows Server 2003 OEM-Disk for EXPRESSBUILDER.
NOTE:
If you have already "Windows Server 2003 OEM-Disk for EXPRESSBUILDER"
for the server on which you are going to install Windows Server 2003, you do not need to
create it again.
You can create Windows Server 2003 OEM-Disk for EXPRESSBUILDER with the following two procedures.
Create from the menu which appears when running the server with EXPRESSBUILDER.
If you have only the server to create Windows Server 2003 OEM-Disk for EXPRESSBUILDER, use this
procedure.
If Windows Server 2003 or Windows can be operated on the server, you can use the other procedure described
later.
Follow the steps below.
4.
Prepare one 3.5-inch floppy disk.
5.
Turn on your server.
6.
Insert the EXPRESSBUILDER DVD into the CD-RW/DVD-ROM drive of the server.
7.
Press the RESET switch or press Ctrl, Alt and Delete to reboot the server. (You may also turn off and then
on again to reboot the server.)
The system will boot from the DVD-ROM and EXPRESSBUILDER starts.
8.
Select [Create the OEM-DISK for Windows] from [Tools Menu] step.
9.
Select [Create an Windows Server 2003 OEM-Disk for EXPRESSBUILDER] at [Create OEM-Disk] and
click [Perform].
10.
Insert a floppy disk into the floppy disk drive according to the on-screen instructions.
Windows Server 2003 OEM-Disk for EXPRESSBUILDER will be created.
Write-protect and attach a label, then keep it safely.
E-4
Advertisement
Table of Contents
