Table of Contents
Advertisement
Installing with the OEM-FD for Mass Storage Device
This section explains how to setup with the OEM-FD. This is not a standard procedure. The detailed information is
provided by the manual of the Mass Storage Device.
Installation of a Mass storage device not supported by Express Setup
If you would like to install or re-install the OS when the system has a new mass storage device not supported by the
EXPRESSBUILDER, you have to set as follows.
1.
Read the manual supplied with the mass storage device before setting the server.
2.
If the mass storage device is a RAID Controller, configure the RAID system before running the
EXPRESSBUILDER.
3.
Boot the system from the EXPRESSBUILDER DVD.
4.
(a) When the "Use Existing Array" dialog box appears, check "Skip Creating a Virtual disk".
(b) Check "Apply OEM-FD for Mass storage device".
5.
Copy the driver for the mass storage device in the Express Setup.
Insert the floppy disk attached to the mass storage device into the floppy disk drive.
Follow the on-screen messages to continue the Express Setup.
5-25
Advertisement
Table of Contents
