Solenoid Harness Adapter Seal - Jeep cherokee 2000 Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
Fig. 69 Installing Transmission Valve Body Oil
Fig. 70 TCM Location (Left Hand Drive)
1 – TCM
2 – LOWER FINISH PANEL
Fig. 71 TCM Location (Right Hand Drive)
1 – REAR SIDE OF INSTRUMENT PANEL
2 – TCM AND HARNESS
module from the finish panel. Tighten the module
mounting screws securely after installation. Also be
sure the wire harness is not twisted, kinked or touch-
ing any body panels.
Tubes
AW–4 AUTOMATIC TRANSMISSION

SOLENOID HARNESS ADAPTER SEAL

REMOVAL
(1) Remove oil pan and oil screen.
(2) Disconnect solenoid wire connectors (Fig. 72).
Fig. 72 Solenoid Wire Connectors
1 – SOLENOID WIRE CONNECTORS
(3) Remove bracket securing solenoid harness
adaptor (Fig. 73) to case.
Fig. 73 Harness Adapter Removal/Installation
1 – HARNESS ADAPTER
2 – BRACKET
(4) Pull harness adapter and wires out of case.
21 - 261