Jeep cherokee 2000 Service Manual page 820

13 - 2 FRAME AND BUMPERS
REMOVAL AND INSTALLATION
FRONT BUMPER END CAP . . . . . . . . . . . . . . . . . . 2
FRONT BUMPER . . . . . . . . . . . . . . . . . . . . . . . . . . 3
FRONT TOW HOOK. . . . . . . . . . . . . . . . . . . . . . . . 3
REMOVAL AND INSTALLATION
FRONT BUMPER END CAP
REMOVAL
(1) Remove the rivet attaching the end cap to the
air deflector.
(2) Remove the bolts and nuts attaching the end
cap to the bumper (Fig. 1).
(3) Pull back the wheelhouse liner and remove the
screws attaching the end cap to the front fender.
1 – U-NUT
2 – TOW HOOK SUPPORT BRACKET
3 – END CAP
4 – RIVET
BUMPERS
TABLE OF CONTENTS
page
REAR BUMPER END CAP . . . . . . . . . . . . . . . . . . . 4
REAR BUMPER . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
REAR TOW HOOK . . . . . . . . . . . . . . . . . . . . . . . . . 5
(4) Lifting the end cap from the bottom, tilt
slightly upward and slide it outward to disengage the
retainer tab from the bumper (Fig. 2).
(5) Separate the end cap from the bumper.
INSTALLATION
(1) Position the end cap on the bumper and engage
the retaining tab.
(2) Install the screws attaching the end cap to the
front fender.
(3) Install the bolts attaching the end cap to the
bumper. Tighten the nut to 9 N·m (7 ft. lbs.) torque.
Fig. 1 Front Bumper
5 – AIR DEFLECTOR
6 – MOUNTING BRACKET
7 – BUMPER
XJ
page