Manual Valve Shaft Seal - Jeep cherokee 2000 Service Manual

21 - 262 AW–4 AUTOMATIC TRANSMISSION
REMOVAL AND INSTALLATION (Continued)
(5) Remove and discard adapter O–ring.
INSTALLATION
(1) Lubricate new O–ring and install it on adapter.
(2) Install solenoid wire harness and adapter in
case.
(3) Install adapter bracket and bracket bolt.
(4) Connect wires to solenoids.
(5) Install oil screen.
(6) Apply bead of Threeebond
TB1281, P/N 83504038, to oil pan seal surface.
Sealer bead should be at least 3 mm (1/8 in.) wide.
(7) Install oil pan on transmission. Tighten pan
bolts to 7 N·m (65 in. lbs.) torque.
(8) Install and tighten oil pan drain plug to 20
N·m (15 ft. lbs.) torque.
(9) Fill transmission with Mopar Dexron IIE/Mer-
con.

MANUAL VALVE SHAFT SEAL

REMOVAL
Fig. 74 Manual Valve Shaft And Seals
1 – SHAFT SEAL
2 – PIN
3 – MANUAL VALVE SHAFT
4 – SHAFT SEAL
5 – SPACER SLEEVE
6 – SHIFT SECTOR
(1) Remove park/neutral position switch and dis-
connect transmission shift lever (Fig. 74).
(2) Remove oil pan and valve body.
(3) Remove bolts attaching park rod bracket to
case (Fig. 75).
Liquid Gasket
1 – PARK ROD
2 – PARK ROD BRACKET
(4) Remove park rod from shift sector (Fig. 76).
1 – SHIFT SECTOR
2 – MANUAL VALVE SHAFT
3 – PARK ROD
(5) Cut spacer sleeve with chisel and remove it
from manual valve shaft (Fig. 77).
(6) Remove pin from shaft and sector with pin
punch.
(7) Remove shaft and sector from case.
Fig. 75 Removing/Installing Park Rod Bracket
Fig. 76 Removing/Installing Park Rod
XJ