Rear Door Glass Run Channel Weatherstrip; Rear Door Glass Exterior Molding; Rear Door Weatherstrip - Jeep cherokee 2000 Service Manual

23 - 46 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 53 Rear Door Inner/Outer Belt Weatherstrip
1 – OUTER BELT WEATHERSTRIP
2 – INNER BELT WEATHERSTRIP
3 – GLASS CHANNEL WEATHERSTRIP
4 – DOOR INNER PANEL
5 – GLASS CHANNEL
6 – DOOR OUTER PANEL
INSTALLATION
(1) Position the weatherstrip on the door.
(2) Push weatherstrip down to seat onto door.
REAR DOOR GLASS RUN CHANNEL
WEATHERSTRIP
REMOVAL
(1) Remove door trim panel.
(2) Remove waterdam.
(3) Remove window glass.
(4) Starting at rear corner, peel weatherstrip from
around door frame (Fig. 53).
INSTALLATION
(1) Starting at the top corner, press seal into place.
A small amount of adhesive can be used to hold the
weatherstrip in-place, if necessary.
(2) As applicable, move downward evenly until the
weatherstrip seal is fully seated in the channel.
(3) Install window glass.
(4) Install waterdam.
(5) Install door trim panel.

REAR DOOR GLASS EXTERIOR MOLDING

REMOVAL
(1) Open the window.
(2) Remove the outer belt molding.
(3) Pry and pull the molding sections from the
door panel flange (Fig. 54).
Fig. 54 Rear Glass Exterior Molding
1 – UPPER MOLDING
2 – MOLDING
3 – SHIM
4 – OUTER BELT MOLDING
5 – SHIM
6 – OUTER DOOR PANEL
INSTALLATION
(1) Starting at the forward end of the upper mold-
ing, force the molding onto the door panel flange and
continue rearward until it is completely seated on
the flange.
(2) Mate the rear molding with the upper molding
and force the molding edge inward.
(3) Continue pressing and moving downward to
complete the installation.
(4) Install the outer belt molding.

REAR DOOR WEATHERSTRIP

REMOVAL
(1) Remove B-pillar upper trim.
(2) Remove inner scuff plate.
(3) Remove B-pillar lower trim.
(4) Remove upper door opening trim.
(5) Grasp seal and separate from door opening
(Fig. 55).
XJ