Rear Fender Flare; Quarter Window Applique; Drip Rail Molding - Jeep cherokee 2000 Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)
Fig. 60 Body Side Molding—4-Door
(3) Remove the backing from the tape, align the
molding and position it on the body panel.
(4) Press the molding onto the body panel with a
roller or hand pressure.

REAR FENDER FLARE

REMOVAL
(1) Remove the screw attaching the lower part of
flare to the bottom of the fender.
(2) Remove the nuts attaching the fender flare
retainer to the wheelhouse liner (Fig. 61).
(3) Separate the fender flare and retainer from the
fender.
Fig. 61 Fender Flare
1 – CENTER RETAINER
2 – WHEELHOUSE LINER
3 – BODY
4 – REAR RETAINER
5 – FENDER FLARE
INSTALLATION
(1) Position the fender flare and retainer on the
fender.
(2) Install the nuts attaching the fender flare and
retainer to the wheelhouse liner.
(3) Install the screw attaching the lower part of
flare to the bottom of the fender.

QUARTER WINDOW APPLIQUE

REMOVAL
(1) Remove the liftgate pillar trim.
(2) Remove nuts from inside vehicle (Fig. 62).
(3) Using a trim sick or equivalent, carefully pry
the applique the from panel.
INSTALLATION
(1) Position the replacement applique the on panel
and install the nuts.
(2) Install the liftgate pillar trim.
Fig. 62 Quarter Window Applique and Drip Molding
1 – VEHICLE ROOF
2 – DRIP MOLDING
3 – DRIP MOLDING CLIP
4 – DRIP MOLDING
5 – CLIP
6 – QUARTER WINDOW APPLIQUE
7 – VEHICLE BODY
8 – NUT
9 – SEALANT

DRIP RAIL MOLDING

REMOVAL
(1) Pry the clips from the roof flange.
(2) Remove the clips and molding from the roof
flange (Fig. 62).
BODY 23 - 49