Vehicle Speed Sensor; Specifications; Torque Chart - Jeep cherokee 2000 Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)

VEHICLE SPEED SENSOR

The Vehicle Speed Sensor (VSS) is located on the
speedometer pinion gear adapter. If equipped with
4WD, this adapter is located on the transfer case
extension (left side) (Fig. 43). If equipped with 2WD,
this adapter is located on the extension housing of
the transmission (left side).
Fig. 43 VSS Location—4WD Shown
1 – SENSOR ELECTRICAL CONNECTOR
2 – SLIDE TAB
3 – 4WD TRANSFER CASE EXTENSION
4 – VEHICLE SPEED SENSOR
5 – RELEASE LOCK
REMOVAL
(1) Raise and support vehicle.
(2) Disconnect electrical connector from sensor by
pushing slide tab (Fig. 43). After slide tab has been
positioned, push in on secondary release lock (Fig. 43)
on side of connector and pull connector from sensor.
(3) Remove sensor mounting bolt (Fig. 44).
(4) Remove sensor (pull straight out) from speed-
ometer pinion gear adapter (Fig. 44). Do not remove
gear adapter from transmission.
INSTALLATION
(1) Clean inside of
adapter before installing speed sensor.
(2) Install sensor into speedometer gear adapter
and install mounting bolt. Before tightening bolt,
verify speed sensor is fully seated (mounted
flush) to speedometer pinion gear adapter.
(3) Tighten sensor mounting bolt to 2.2 N·m (20 in.
lbs.) torque.
(4) Connect electrical connector to sensor.
speedometer pinion
Fig. 44 VSS Removal/Installation
1 – ELECTRICAL CONNECTOR
2 – SENSOR MOUNTING BOLT
3 – O-RING
4 – SPEEDOMETER PINION GEAR
5 – SPEEDOMETER PINION GEAR ADAPTER
6 – O-RING
7 – VEHICLE SPEED SENSOR

SPECIFICATIONS

TORQUE CHART

DESCRIPTION
Air Cleaner Housing Mount. Bolts . . . . . . . . 8 N·m
Engine Coolant Temperature Sensor . . . . . . 11 N·m
IAC Motor-To-Throttle Body Bolts . . . . . . . . 7 N·m
Intake Manifold Air Temp. Sensor . . . . . . . 28 N·m
MAP Sensor Mounting Screws . . 3 N·m (25 in. lbs.)
Oxygen Sensor . . . . . . . . . . . . . 30 N·m (22 ft. lbs.)
PCM Mounting Screws . . . . . . . . 4 N·m (35 in. lbs.)
Power Steering Pressure Switch . . . . . . 14–22 N·m
gear
Throttle Body Mounting Bolts . . . . . . . . . . . 11 N·m
Throttle Position Sensor Mounting Screws . . 7 N·m
Vehicle Speed Sensor Mounting Bolt . . . . . 2.2 N·m
FUEL SYSTEM 14 - 51
TORQUE
(71 in. lbs.)
(96 in. lbs.)
(60 in. lbs.)
(20 ft. lbs.)
(124–195 in. lbs.)
(100 in. lbs.)
(60 in. lbs.)
(20 in. lbs.)