Engine Assembly - Jeep cherokee 2000 Service Manual

9 - 92 4.0L ENGINE
REMOVAL AND INSTALLATION (Continued)
Fig. 46 Rear Mount(Manual Transmission)
1 – TRANSMISSION SUPPORT BRACKET
2 – SUPPORT CUSHION
3 – CROSSMEMBER ASSEMBLY
b. Install the support cushion to the support
bracket. Install the nuts and tighten to 75 N·m (55
ft. lbs.) torque.
AUTOMATIC TRANSMISSION:
a. On 2WD vehicles, position the transmission
support adaptor bracket to the transmission. Install
the bolts and tighten to 75 N·m (55 ft. lbs.) torque.
b. Position the transmission support bracket and
support cushion to the adaptor bracket (2WD) or the
transmission (4WD). Install the bolts and tighten to
75 N·m (55 ft. lbs.) torque.
(1) Position the crossmember onto the support
cushion studs. Install the stud nuts and tighten to 22
N·m (192 in. lbs) torque.
(2) Install crossmember-to-sill bolts and tighten to
41 N·m (30 ft. lbs.) torque.
(3) Remove the transmission support.
(4) Lower the vehicle.
(5) Connect negative cable to battery.

ENGINE ASSEMBLY

REMOVAL
(1) Disconnect the battery cables. Remove the bat-
tery.
(2) Mark the hinge locations on the hood panel for
alignment reference during installation. Remove the
engine compartment lamp. Remove the hood.
Fig. 47 Rear Mount(Automatic Transmission)
1 – 4 4
2 – 2 4
3 – TRANSMISSION SUPPORT ADAPTOR BRACKET
4 – SUPPORT CUSHION
5 – CROSSMEMBER ASSEMBLY
6 – TRANSMISSION SUPPORT BRACKET
WARNING: THE COOLANT IN A RECENTLY OPER-
ATED ENGINE IS HOT AND PRESSURIZED. USE
CARE TO PREVENT SCALDING BY HOT COOLANT.
CAREFULLY RELEASE THE PRESSURE BEFORE
REMOVING THE RADIATOR DRAIN COCK AND CAP.
(3) Remove the air cleaner assembly.
(4) Loosen the radiator drain cock and radiator cap
to drain the coolant. DO NOT waste usable coolant.
If the solution is clean, drain the coolant into a clean
container for reuse.
(5) Remove the lower radiator hose.
(6) Remove the upper radiator hose and coolant
recovery hose (Fig. 48).
(7) Remove upper radiator support retaining bolts
and remove radiator support.
(8) Remove the fan shroud (Fig. 48) and electric
cooling fan.
(9) Disconnect the transmission fluid cooler tubing
(automatic transmission).
XJ