Jeep cherokee 2000 Service Manual page 977

XJ
DISASSEMBLY AND ASSEMBLY (Continued)
1 – DOUBLE GROOVE FORWARD
2 – GROOVE FORWARD
3 – FIRST GEAR SIDE MARKING TOWARD FIRST GEAR
4 – TAPER FORWARD
Fig. 87 Idler Gear And Bearing Installation
1 – IDLER GEAR
2 – BEARING
3 – LOCK BALL
4 – REAR OF SHAFT
(8) Install front thrust washer on shaft and slide
washer up against gear and over lock ball (Fig. 89).
Fig. 86 Correct Synchro Sleeve Position
NV3550 MANUAL TRANSMISSION
5 – GROOVE FORWARD
6 – 5TH-REV SYNCHRO SLEEVE
7 – 1–2 SYNCHRO SLEEVE
8 – 3–4 SYNCHRO SLEEVE
Fig. 88 Idler Gear Rear Thrust Washer Installation
1 – LOCK BALL
2 – SNAP RING GROOVE
3 – THRUST WASHER
(9) Install wave washer, flat washer and remain-
ing snap ring on idler shaft (Fig. 89). Be sure snap
ring is fully seated.
21 - 69