Jeep cherokee 2000 Service Manual page 986

21 - 78 NV3550 MANUAL TRANSMISSION
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 113 Inserting Shaft Into Lever Opening In
1 – SHIFT SHAFT
Fig. 114 Shift Socket Installation
1 – SHIFT SOCKET
2 – SHIFT SHAFT
CAUTION: Correct positioning of the shift shaft
detent notch is important. Both of the shaft roll pins
can be installed even when the shaft is 180° off. If
this occurs, the transmission will have to be disas-
sembled again to correct shaft alignment.
(9) Select correct new roll pin for shift shaft lever
(Fig. 115). Shaft lever roll pin is approximately 22
mm (7/8 in.) long. Shift socket roll pin is approxi-
mately 33 mm (1-1/4 in.) long.
Housing
Fig. 115 Roll Pin Identification—Shaft Lever And
Shift Socket
1 – SHAFT LEVER ROLL PIN
2 – SHIFT SOCKET ROLL PIN
(10) Align roll pin holes in shift shaft, lever and
bushing. Then start roll pin into shaft lever by hand
(Fig. 116).
Fig. 116 Starting Roll Pin In Shift Shaft Lever
1 – SHAFT LEVER ROLL PIN (
2 – LEVER AND BUSHING
(11) Seat shaft lever roll pin with pin punch (Fig.
117).
CAUTION: The shaft lever roll pin must be flush
with the surface of the lever. The lever bushing will
bind on the roll pin if the pin is not seated flush.
(12) Before proceeding, verify that lock pin slot in
lever bushing is positioned as shown (Fig. 117).
(13) Align roll pin holes in shift socket and shift
shaft. Then start roll pin into shift shaft by hand
(Fig. 118).
⁄ " LONG)
7
8
XJ