Jeep cherokee 2000 Service Manual page 1079

XJ
DISASSEMBLY AND ASSEMBLY (Continued)
(21) Install and tighten rear support bolts to 17
N·m (150 in. lbs.) torque.
(22) Install snap ring to retain low-reverse drum
to hub of rear support (Fig. 148).
Fig. 148 Low-Reverse Drum Snap Ring
1 – REAR BAND
2 – REAR SUPPORT HUB
3 – LOW-REVERSE DRUM SNAP RING
4 – LOW-REVERSE DRUM
(23) Lubricate output shaft, rear support bore and
low-reverse drum hub with transmission fluid.
(24) Install assembled output shaft and planetary
geartrain in case (Fig. 149).
(25) Align drive lugs on rear planetary gear with
slots in low-reverse drum (Fig. 149). Then seat plan-
etary assembly in drum.
(26) Install governor on output shaft.
Fig. 149 Output Shaft And Planetary Geartrain
1 – SLOTS
2 – LOW-REVERSE DRUM
3 – PLANETARY GEARTRAIN
4 – TRANSMISSION HOUSING
5 – LUGS
AUTOMATIC TRANSMISSION—30RH
(27) Turn and secure transmission so that front
opening is upward.
(28) Assemble front and rear clutches together.
(a) Check input shaft seal rings (Fig. 150). Verify
that diagonal-cut ends of Teflon
properly joined and ends of metal ring are correctly
hooked together. Also be sure rings are installed in
sequence shown.
(b) Align teeth on clutch discs in line.
(c) Insert input shaft on rear clutch into center
of front clutch (Fig. 151).
(d) Engage teeth on rear clutch hub into teeth on
clutch (Fig. 153). Rotate front clutch retainer back
and forth until completely seated on rear clutch.
Fig. 150 Input Shaft Seal Ring Location
1 – INPUT SHAFT
2 – TEFLON SEAL RING
3 – METAL SEAL RING
4 – REAR CLUTCH RETAINER
Fig. 151 Front and Rear Clutches
1 – REAR CLUTCH
2 – INPUT SHAFT
3 – FRONT CLUTCH
21 - 171
seal ring are