Transmission Valve Body - Jeep cherokee 2000 Service Manual

XJ
REMOVAL AND INSTALLATION (Continued)

TRANSMISSION VALVE BODY

REMOVAL
(1) Remove oil pan plug and drain transmission
fluid.
(2) Remove oil pan and oil screen. Clean pan and
screen in solvent and dry them with compressed air.
(3) Disconnect solenoid wire connectors (Fig. 62).
Mark wires for assembly reference.
Fig. 62 Solenoid Wire Connectors
1 – SOLENOID WIRE CONNECTORS
(4) Remove valve body oil tubes (Fig. 63). Carefully
pry tubes out of valve body with screwdriver.
(5) Disconnect throttle cable from throttle cam
(Fig. 64).
(6) Remove valve body bolts. Bolt locations are
outlined in (Fig. 65).
(7) Lower valve body and remove overdrive clutch
accumulator springs,
springs and second brake accumulator spring (Fig.
66).
(8) Remove valve body and check ball and spring
(Fig. 67).
INSTALLATION
(1) Connect cable to throttle cam (Fig. 64).
(2) Install check ball and spring (Fig. 67).
(3) Position accumulator springs and spacers on
valve body.
(4) Align valve body manual valve with shift sector
(Fig. 68) and carefully position valve body on case.
(5) Install valve body bolts (Fig. 65). Tighten bolts
evenly to 10 N·m (7 ft. lbs.) torque.
direct clutch accumulator
AW–4 AUTOMATIC TRANSMISSION
Fig. 63 Removing Transmission Valve Body Oil
1 – OIL TUBES
Fig. 64 Removing/Installing Throttle Cable
1 – THROTTLE CABLE
2 – CABLE BRACKET
(6) Install valve body oil tubes. Be sure tube ends
(L) and (M) are installed as shown in (Fig. 69).
(7) Remove old sealer material from oil pan and
transmission case.
(8) Clean oil screen and oil pan with solvent (if not
done previously). Dry both components with com-
pressed air only. Do not use shop towels.
(9) Install new gaskets on oil screen and install
screen on case. Tighten screen attaching bolts to 10
N·m (7 ft. lbs.) torque.
21 - 259
Tubes