Ax5 Manual Transmission; Description And Operation; Lubricant - Jeep cherokee 2000 Service Manual

21 - 2

AX5 MANUAL TRANSMISSION

DESCRIPTION AND OPERATION (Continued)
Fig. 2 Transmission Identification
1 – I. D. CODE ON CASE NEAR DRAIN PLUG
engaged. The input shaft is connected to the trans-
mission countershaft through the mesh of fourth
speed gear on the input shaft and the fourth counter-
shaft gear. At this point, all the transmission gears
are spinning.
The driver selects a particular gear by moving the
shift lever to the desired gear position. This move-
ment moves the internal transmission shift compo-
Fig. 1 AX5 Manual Transmission
nents to begin the shift sequence. As the shift lever
moves the selected shift rail, the shift fork attached
to that rail begins to move. The fork is positioned in
a groove in the outer circumference of the synchro-
nizer sleeve. As the shift fork moves the synchronizer
sleeve, the synchronizer begins to speed-up or slow
down the selected gear (depending on whether we are
up-shifting or down-shifting). The synchronizer does
this by having the synchronizer hub splined to the
mainshaft, or the countershaft in some cases, and
moving the blocker ring into contact with the gear's
friction cone. As the blocker ring and friction cone
come together, the gear speed is brought up or down
to the speed of the synchronizer. As the two speeds
match, the splines on the inside of the synchronizer
sleeve become aligned with the teeth on the blocker
ring and the friction cone and eventually will slide
over the teeth, locking the gear to the mainshaft, or
countershaft, through the synchronizer.

LUBRICANT

DESCRIPTION
Recommended lubricant for AX5 transmissions is
Mopar 75W–90, API Grade GL–3 gear lubricant, or
equivalent.
Correct lubricant level is from the bottom edge, to
no more than 6 mm (1/4 in.) below the bottom edge of
the fill plug hole.
The fill plug is on the passenger side of the
adapter housing (Fig. 3). The drain plug is on the
bottom of the case.
XJ