Jeep cherokee 2000 Service Manual page 1269

XJ
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 46 Output Shaft Rear Bearing Removal
1 – REAR CASE
2 – SPECIAL TOOL L-4454–1 AND L-4454–3
3 – SPECIAL TOOL 8148
Fig. 47 Output Shaft Rear Bearing Installation
1 – HANDLE C-4171
2 – OUTPUT SHAFT INNER BEARING
3 – INSTALLER 5066
NV231 TRANSFER CASE
Fig. 48 Output Shaft Rear Bearing Installation Depth
1 – BEARING (SEATED) AT LOWER EDGE OF CHAMFER
2 – CHAMFER
(9) Using Remover C-4210 and Handle C-4171,
drive input shaft bearing from inside the annulus
gear opening in the case. (Fig. 49).
Fig. 49 Input Shaft Bearing Removal
1 – SPECIAL TOOL C-4171
2 – SPECIAL TOOL C-4210
(10) Install locating ring on new bearing.
(11) Position case so forward end is facing upward.
(12) Using Remover C-4210 and Handle C-4171,
drive input shaft bearing into case. The bearing
locating ring must be fully seated against case sur-
face (Fig. 50).
(13) Remove input gear pilot bearing by inserting
a suitably sized drift into the splined end of the input
gear and driving the bearing out with the drift and a
hammer (Fig. 51).
(14) Install new pilot bearing with Installer 5065
and Handle C-4171 (Fig. 52).
21 - 361