Jeep cherokee 2000 Service Manual page 1204

21 - 296 AW–4 AUTOMATIC TRANSMISSION
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 191 Installing Transmission Speed Sensor
Rotor And Key
1 – SPEED SENSOR ROTOR
2 – ROTOR KEY
Fig. 192 Installing Spacer And Speedometer Drive
1 – SPEEDOMETER DRIVE GEAR
2 – SNAP RING
3 – SPACER
(95) Install adapter housing on transmission.
Tighten adapter bolts to 34 N·m (25 ft. lbs.) torque.
(96) Install transmission speed sensor (Fig. 194).
Tighten sensor bolt to 7.4 N·m (65 in. lbs.) torque
and connect sensor wire harness connector.
(97) Install converter housing (Fig. 195). Tighten
12 mm diameter housing bolts to 57 N·m (42 ft. lbs.)
torque. Tighten 10 mm diameter housing bolts to 34
N·m (25 ft. lbs.) torque.
Gear
Fig. 193 Applying Sealer To Case Rear Flange
1 – SEALER BEAD
2 – CASE REAR FLANGE
Fig. 194 Installing Transmission Speed Sensor
1 – SENSOR BOLT
2 – SPEED SENSOR
(98) Install transmission shift lever on manual
valve shaft. Do not install lever attaching nut at this
time.
(99) Move transmission shift lever fully rearward.
Then move lever two detent positions forward.
(100) Mount park/neutral position switch on man-
ual valve shaft and tighten switch adjusting bolt just
enough to keep switch from moving (Fig. 196).
(101) Install park/neutral position switch tabbed
washer and retaining nut (Fig. 196). Tighten nut to
XJ