3: Installation & Setup; Assembly And Connection Of Components - Christie CP2000-SB Setup Manual

3 Installation & Setup
in a restricted access location.
Ensure the following tools and components are on hand before beginning. NOTE: In general,
fasteners are metric sizes and require metric tools. However, to complete lamp installation, imperial
tools are required, which are provided inside the lamp door of the projector.
 12" screwdrivers: Phillips (magnetic) and flat
 Assorted wrenches such as 7/8" and 3/4"
 Assorted Allen keys such as 3/16", 7/64", 5/32", and M3
 3-phase 4-wire, 5-wire, or 6-wire connection of AC supply to Terminal Block 1 in pedestal
(certified electrician required)
 Heat extractor (such as inline centrifugal blower Elicent model# AXC 315B) or roof extractor
providing at least 450 CFM (2 or 3 kW lamps) or 600 CFM (4.5 or 6 kW lamps) at 8" exhaust
duct opening @ 600 watts or lower. NOTE: Mount at an external location
 Lamp and protective clothing / safety gear
 Laptop computer with DCP Librarian setup software with Ethernet or standard RS-232 cable
 Vapor-free dustoff type compressed air can
 Latex lab gloves
 Lens cleaning tissue and solution (refer to
3.1

Assembly and Connection of Components

These instructions describe how to:
• mount the projection head onto the pedestal
• position the projector relative to the port window and screen
• connect pedestal-to-head cabling and cooling hoses
• customize projector for CP2000-SB lamps
• connect exhaust ducting and fill liquid cooling system
• install lens and lamp
• connect to power
projector. Replacement involves dispatching a field technician to the site at owner's
expense. 2) Qualified technician required for all installation steps. Do not modify cir-
cuits or wiring.
CP2000-SB Setup Guide
020-100249-02 Rev. 1 (05-2009)
All installation procedures must be performed by a qualified technician
1) DO NOT misplace High Security keys, which are packed with the
Section 4.1 Maintenance and Cleaning)
3-1