Supported Hardware Setup - Christie CP2000-SB Setup Manual

Section 2: Basic Operation
• IR emitter for controlling the L/R gating (switching) of active glasses
OR
• Pi-Cell polarizer for controlling a screen that has a silver polarization-preserving surface for use with
passive glasses
• Custom 3D Sync Output Cable (GPIO) such as available from RealD:
• For routing the projector's output sync to your Sync Output Device-connect from the projector's GPIO.
NOTE: Accessed from within the pedestal-refer to
izer.
NOTE: Refer to Appendix D: GPIO from the CP2000-SB User Manual (020-100162-xx) for GPIO pinouts
and other 3D sync cable details.
• Power supply for your Sync Output Device, typically wired with the custom GPIO cable.
• Proper 3D configuration defined in the TPC's Custom: 3D Control menu. For best results, use the 3D inter-
nal test pattern shown in Figure 2-5.

2.6.3 Supported Hardware Setup

Figure 2-5 shows the general hardware configuration currently supported. Use either an IR emitter to control
gating in active glasses, or a polarizing cell and Z-screen with passive glasses.
NOTES: 1) All configurations require a custom 3D Sync Cable, such as supplied by RealD, for the GPIO port.
2) A pull-up power supply (not shown) is also required for the IR emitter or polarizing cell. 3) Refer to
Appendix D: GPIO from the CP2000-SB User Manual (020-100162-xx) for cabling details.
Figure 2-5 Typical Dual-Input 3D System (CP2000 Shown with Active Glasses)
2-10
Section 3 Installation & Setup) to the emitter or polar-
CP2000-SB Setup Guide
020-100249-02 Rev. 1 (05-2009)