Christie CP2000-SB Setup Manual page 29

6. Route the NEGATIVE (–) BLACK lamp lead through the hole in the cooling compartment floor
(Figure 3-11). The igniter wires from terminal 5 and the PCB are also routed here.
7. A universal connector nut should be pre-installed on the cathode-end lamp post. Regardless of
model or lamp size, this nut is 1.658" in overall length. See right. NOTE: The universal nut shown
accommodates all models. Do not install a shorter nut. Important! Ball joint must move freely. If
necessary, hand tighten with 9/64" Allen key.
8. With 3/16" Allen key, secure the
the side of the connector nut. Important! Secure lamp lead FIRST on connector, then remaining two
igniter wires on TOP.
At this point, the lamp pre-wiring is complete. Leave lamp accessible for now.
CP2000-SB Setup Guide
020-100249-02 Rev. 1 (05-2009)
Figure 3-11 Feed Black Lead
into Compartment
Figure 3-12 Connector Nut
NEGATIVE (–) BLACK
Figure 3-13 Secure Lamp
Lead and Two Igniter Wires
Section 3: Installation & Setup
lamp lead and the two igniter harnesses to
3-7