Christie CP2000-SB Setup Manual page 25

Note that when a particularly short throw distance combines with a very wide screen, you may have to for-
feit some aim and stay more parallel to the screen. In such cases, some lens offset can reduce the keystone
distortion. Later, when your projector is up-and-running, adjust precise image geometry and placement as
described in
STEP 3 - Extend All Feet
For permanent installations and more stable images, the
projector should be firmly on the floor rather than on its
casters. Extend (rotate) the foot located behind each
caster until the lens opening is fairly well-centered with
the port window (Figure 3-3). Lock top nut in place.
Remove caster if desired. NOTE: There is no need to
adjust leveling and/or tilt at this point—wait until all
other components are mounted/installed, and refer to
Section 3.5 Adjusting Tilt and
STEP 4 - Install Touch Panel Controller
a. Attach the Touch Panel Controller (TPC), pre-assembled
with its ball joint base and mounting arm, to the matching
ball joint base secured at the rear of the projector (Figure 3-
4).
b. Connect to the TPC cable routed through the nearby hole in
the projector rear. The other end of this cable is pre-con-
nected to the internal Ethernet hub and the 24V power sup-
ply.
If desired, you can mount the TPC and its 24V power supply
elsewhere at the site. Route the TPC cable through either the rear
or front hole on the projector. Cap the unused hole.
CP2000-SB Setup Guide
020-100249-02 Rev. 1 (05-2009)
Figure 3-2 Centering < > (Aerial Views)
Section 3.8 Basic Image
Leveling.
Alignment.
Section 3: Installation & Setup
Figure 3-3 Adjust Feet
Figure 3-4 Typical TPC Mounting
3-3