Christie CP2000-SB Setup Manual page 41

3. Remove the rear bottom panel (2 top screws, 2 bottom tabs) from the CP pedestal (Figure 3-30).
4. Use a low-profile scissor jack to elevate the rear of the projector.
5. On each side of the rear opening in the pedestal, loosen the 2 bolts securing the rear extender legs to the
projector (Figure 3-31).
6. Slide the legs out to the desired position and secure with two bolts.
7. Remove the jack.
8. If necessary, re-adjust all leveling feet for side-to-side leveling (Figure 3-29). Note that you may have to
adjust level more precisely once an image is present.
CP2000-SB Setup Guide
020-100249-02 Rev. 1 (05-2009)
Figure 3-30 Open Rear of Pedestal
Figure 3-31 Adjust Rear Extender Legs
Section 3: Installation & Setup
3-19