Christie CP2000-SB Setup Manual page 28

Hide thumbs Also See for CP2000-SB:

Table of Contents

Section 3: Installation & Setup

CONNECT LAMP LEADS

1. Ensure the igniter door is open. From the ballast in the pedestal, route the main black and white

lamp leads through the nearby hole in the underside of the projection head. See Figure 3-9.

2. Route the NEGATIVE (-) BLACK lamp lead through the hole in the lamp cooling compartment

wall. Warning! 1) Ensure the PCB is directed toward the back and remains at least ¾" from the high-

voltage terminal (with braid connection). 2) Route all igniter wires AWAY from 9-pin and 15-pin con-

nectors. 3) Twist both ballast cables twice-per-foot.

3. Connect the POSITIVE (+) WHITE lamp lead to the POSITIVE (+) igniter terminal (3/4"

wrench). This terminal also has a small PCB attached—stack this on top of the lamp lead.

4. Close and lock the igniter door.

IN THE LAMP COOLING COMPARTMENT:

5. With the lamp door removed (refer back to Figure 3-5), turn the small knob and swing open the

lamp cooling compartment door (Figure 3-10).

3-6

Figure 3-9 Connect Lamp Leads

Figure 3-10 Accessing Cathode End

CP2000-SB Setup Guide

020-100249-02 Rev. 1 (05-2009)

Table of Contents