B&R Industries Power Panel 300 User Manual page 542

Appendix A • Mounting compatibilities
The larger cutout can can be conditionally used for all devices:
• When mounting, make sure that the PP100/200/300/400 devices are placed and
mounted as close to the center of the cutout as possible. Failure to do so can prevent the
retaining clips from holding firmly, which means that a firm seal is no longer guaranteed
with the gasket (IP65).
PP100/200/300/400
Figure 349: Mounting compatibility - 10.4" device format - Vertical1
10.4" Power Panel 100/200 and Power Panel 300/400 are not 100% mounting compatible with
the Vertical1 format for the Automation Panel 900 and Panel PC 700 devices. The Automation
Panel 900 and Panel PC 700 devices require a cutout that is 5 mm larger vertically (lower edge).
The larger cutout can can be conditionally used for all devices:
• When mounting, make sure that the PP100/200/300/400 devices are placed and
mounted as close to the center of the cutout as possible. Failure to do so can prevent the
retaining clips from holding firmly, which means that a firm seal is no longer guaranteed
with the gasket (IP65).
542
323 x 358
10
303 x 336 0.5
303 x 341 0.5
Outer contour of device
PP100/200/200/300/400 device cutout
AP900/PPC700 device cutout
10
±
±
Power Panel 300/400 User's Manual V 2.10
8.5
AP900/PPC700
13.5 PP100/200/300/400
8.5 AP900, PPC700