Procedure - B&R Industries Power Panel 300 User Manual

3.4.1 Procedure

The following steps should be taken to update, save or delete a user boot logo:
• Create bootable media.
Information:
In MS-DOS, Win95 and Win98, a blank HD disk can be made bootable using the
command line command "sys a:" or "format a: /s".
Information concerning creating a bootable diskette in Windows XP cab be found on
page 465.
Information concerning creating a USB flash drive for a B&R upgrade can be found
on page 467.
Information concerning creating a CompactFlash card for a B&R upgrade can be
found on page 469.
• Copy the contents of the *.zip file to the bootable media. If the B&R upgrade was already
added when the bootable media was created using the B&R Embedded OS Installer, then
this step is not necessary.
• Create the user boot logo according to section 3.4.2 "Guidelines for creating a user boot
logo" on page 464 and copy to the bootable media.
• Connect the bootable media to the Power Panel and reboot the device. See section
"Motherboard device configuration - drive configuration" on page 405 for the necessary
settings for the Power Panel device when booting from a diskette.
• The following start menu will be shown after booting.
Item Menu item
1 Update BIOS user boot logo
2 Update BIOS default boot logo
Power Panel 300/400 User's Manual V 2.10
Microsoft Windows Startup Menu
===================================
1. Update BIOS User Boot Logo
2. Update BIOS Default Boot Logo
3. Save BIOS Boot Logo
4. Delete BIOS Boot Logo
5. Exit
Enter a choice:_
Figure 316: User boot logo upgrade start menu
Description
The user boot logo is automatically updated with the file USERLOGO.ROM (default
after 5 seconds).
The BIOS default boot logo for the device is automatically updated with the correct
resolution.
Table 180: User boot logo upgrade menu description
Software • Upgrade information
463