Processor And Heat Sink Module; Removing The Processor And Heat Sink Module - Dell PowerEdge XR8610t Installation And Service Manual

Figure 41. Installing a memory module
Next steps
1. Follow the procedure listed in
2. To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System
BIOS > Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of
the installed memory.
3. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. Ensure that the
memory modules are firmly seated in their sockets.
4. Run the system memory test in system diagnostics.

Processor and heat sink module

This is a service technician replaceable part only.

Removing the processor and heat sink module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
NOTE: The heat sink and processor are hot to touch for some time after the system has been powered off. Allow the
heat sink and processor to cool down before handling them.
3. Remove the sled cover.
4. Remove the memory modules.
Steps
1. Ensure all four anti-tilt wires are in the locked position (outward position), and then using a Torx T30 screwdriver, loosen the
captive nuts on the processor heat sink module (PHM) in the order that is mentioned below:
a. Loosen the first nut three turns.
b. Loosen the nut diagonally opposite to the nut you loosened first.
c. Repeat the procedure for the remaining two nuts.
72 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
system.
system.