Installing The Boss-N1 Shroud; Removing The Boss-N1 Card Carrier, M.2 Ssd Module And Boss-N1 Card - Dell PowerEdge XE8640 Installation And Service Manual

Next steps
Install the BOSS-N1 shroud

Installing the BOSS-N1 shroud

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
Align the BOSS-N1 shroud with the BOSS-N1 module bay, lower the shroud into the system and slide to the back of the system
until it is firmly seated.
Figure 86. Installing the BOSS-N1 shroud
Next steps
Follow the procedure listed in
Removing the BOSS-N1 card carrier, M.2 SSD module and BOSS-
N1 card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
Steps
1. Pull and lift the BOSS-N1 card carrier retention latch lock to open.
2. Slide the BOSS-N1 card carrier out.
114 Installing and removing system components
Safety instructions.
Before working inside your
After working inside your system
Safety instructions.
Before working inside your
system.
system.