Danfoss VLT FC 302 Operating Instructions Manual page 46

User Interface
•
an external 24 V supply
At the same time, the back light is on. Indicator lights
(LEDs)
•
Green LED/On: Control section is working.
•
Yellow LED/Warn: Indicates a warning.
•
Flashing Red LED/Alarm: Indicates an alarm.
5 5
Illustration 5.6 LED Status Lights
GLCP keys
Menu keys
The menu keys are divided into functions. The keys below
the display and indicator lamps are used for parameter set-
up, including choice of display indication during normal
operation.
Status
Illustration 5.7 Menu Keys
[Status]
Indicates the status of the frequency converter (and/or the
motor) or the filter respectively. On the drive LCP, 3
different readouts can be selected by pressing the [Status]
key:
5 line readouts, 4 line readouts, or Smart Logic Control.
Smart Logic Control is not available for the filter.
Use [Status] for selecting display mode or reverting to
display mode from:
•
quick menu
•
main menu
•
alarm mode
Use the [Status] key to toggle single or double read-out
mode. Status
[Quick Menu]
Allows quick set-up of the frequency converter or the filter
and programming of the most common functions. Quick
menu
The [Quick Menu] consists of:
•
Q1: My Personal Menu
•
Q2: Quick Setup
•
Q5: Changes Made
•
Q6: Loggings
44
Operating Instructions
On
Warn.
Alarm
Quick Main Alarm
Menu Menu Log
Danfoss A/S © Rev. 2014-07-29 All rights reserved.
Since the active filter is an integrated part of the Low
Harmonic Drive, only a minimum of programming is
necessary. The filter LCP displays information about filter
operation such as THD of voltage or current, corrected
current, injected current or Cos ϕ and true power factor.
The Quick Menu parameters can be accessed immediately
unless a password has been created via parameters 0–60,
0–61, 0–65 or 0–66.
It is possible to switch directly between quick menu mode
and main menu mode.
[Main Menu]
is used for programming all parameters.
The main menu parameters can be accessed immediately
unless a password has been created via parameters 0–60,
0–61, 0–65 or 0–66.
It is possible to switch directly between main menu mode
and quick menu mode.
Parameter shortcut can be carried out by pressing down
the [Main Menu] key for 3 seconds. The parameter
shortcut allows direct access to any parameter.
[Alarm Log]
displays an alarm list of the 5 latest alarms (numbered A1-
A5). To obtain more details about an alarm, use the arrow
keys to navigate to the alarm number and press [OK].
Information is displayed about the condition of the
frequency converter or filter before it enters the alarm
mode.
[Back]
reverts to the previous step or layer in the navigation
structure.
Illustration 5.8 Back Key
[Cancel]
last change or command is cancelled as long as the
display has not been changed.
Illustration 5.9 Cancel Key
[Info]
displays information about a command, parameter, or
function in any display window. [Info] provides detailed
information when needed.
Exit Info mode by pressing either [Info], [Back], or [Cancel].
MG37A202