Mitsubishi Electric FX5 User Manual page 422

Error Error name
code
364BH Axis 11
command speed
error
364CH Axis 12
command speed
error
3651H Axis 1 error stop
(deceleration
stop)
3652H Axis 2 error stop
(deceleration
stop)
3653H Axis 3 error stop
(deceleration
stop)
APPX
420
Appendix 3 Error Code
Error details and cause
• The 32-bit range was exceeded when
the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
• The 32-bit range was exceeded when
the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output due to the limit of the moving
direction or writing during RUN. (The
PLSY/DPLSY instruction stops pulse
output immediately at both limits.)
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output by the pulse decelerate and stop
command.
• When pulses were being output, the
command speed was changed to 0.
• When pulses were being output,
RUN→PAUSE/RUN→STOP operation
was executed.
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output due to the limit of the moving
direction or writing during RUN. (The
PLSY/DPLSY instruction stops pulse
output immediately at both limits.)
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output by the pulse decelerate and stop
command.
• When pulses were being output, the
command speed was changed to 0.
• When pulses were being output,
RUN→PAUSE/RUN→STOP operation
was executed.
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output due to the limit of the moving
direction or writing during RUN. (The
PLSY/DPLSY instruction stops pulse
output immediately at both limits.)
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output by the pulse decelerate and stop
command.
• When pulses were being output, the
command speed was changed to 0.
• When pulses were being output,
RUN→PAUSE/RUN→STOP operation
was executed.
Action
• Start the positioning within specifications.
• Start the positioning within specifications.
• Eliminate the error that has caused the stop
and restart the positioning.
• Eliminate the error that has caused the stop
and restart the positioning.
• Eliminate the error that has caused the stop
and restart the positioning.
Detailed Diagnostic
information timing
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At END
information instruction
and system execution, at
configuration instruction
information execution
Error location At END
information instruction
and system execution, at
configuration instruction
information execution
Error location At END
information instruction
and system execution, at
configuration instruction
information execution