Mitsubishi Electric FX5 User Manual page 420

Error Error name
code
3638H Axis 8 positioning
address error
3639H Axis 9 positioning
address error
363AH Axis 10
positioning
address error
363BH Axis 11
positioning
address error
APPX
418
Appendix 3 Error Code
Error details and cause
• The 32-bit range was exceeded when
the unit of the positioning address was
converted.
• The 32-bit range was exceeded when
the unit of the zero-point address was
converted.
• The total transfer distance before and
after the interrupt of the DVIT/DDVIT
instruction or 1-speed positioning with
interruption exceeded 7FFFFFFFH. Or,
when the operation was started, the
positioning address was set to 0.
• Pulses of 7FFFFFFFH or greater are
needed to specify an absolute address.
• The 32-bit range was exceeded when
the unit of the positioning address was
converted.
• The 32-bit range was exceeded when
the unit of the zero-point address was
converted.
• The total transfer distance before and
after the interrupt of the DVIT/DDVIT
instruction or 1-speed positioning with
interruption exceeded 7FFFFFFFH. Or,
when the operation was started, the
positioning address was set to 0.
• Pulses of 7FFFFFFFH or greater are
needed to specify an absolute address.
• The 32-bit range was exceeded when
the unit of the positioning address was
converted.
• The 32-bit range was exceeded when
the unit of the zero-point address was
converted.
• The total transfer distance before and
after the interrupt of the DVIT/DDVIT
instruction or 1-speed positioning with
interruption exceeded 7FFFFFFFH. Or,
when the operation was started, the
positioning address was set to 0.
• Pulses of 7FFFFFFFH or greater are
needed to specify an absolute address.
• The 32-bit range was exceeded when
the unit of the positioning address was
converted.
• The 32-bit range was exceeded when
the unit of the zero-point address was
converted.
• The total transfer distance before and
after the interrupt of the DVIT/DDVIT
instruction or 1-speed positioning with
interruption exceeded 7FFFFFFFH. Or,
when the operation was started, the
positioning address was set to 0.
• Pulses of 7FFFFFFFH or greater are
needed to specify an absolute address.
Action
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
Detailed Diagnostic
information timing
Error location At END
information instruction
and system execution, at
configuration interrupt
information occurrence
Error location At END
information instruction
and system execution, at
configuration interrupt
information occurrence
Error location At END
information instruction
and system execution, at
configuration interrupt
information occurrence
Error location At END
information instruction
and system execution, at
configuration interrupt
information occurrence