Mitsubishi Electric FX5 User Manual page 343

No. Name
SM8016 Time read display is stopped
±30 seconds correction
SM8017
SM8019 Real time clock error
SM8020 Zero
SM8021 Borrow
SM8022 Carry
SM8023 Real time clock access error
SM8026 RAMP mode
SM8029 Instruction execution complete
SM8031 Non-latch memory all clear
SM8032 Latch memory all clear
SM8033 Memory hold stop
SM8034 All output disable
SM8039 Constant scan mode
SM8040 STL transfer disable
SM8041 Transfer start
SM8042 Start pulse
SM8043 Zero return complete
SM8044 Zero point condition
SM8045 All output reset disable
SM8046 STL state ON
SM8047 Enable STL monitoring
SM8048 Annunciator ON
SM8049 Enable annunciator monitoring
SM8050 I00 disable
SM8051 I10 disable
SM8052 I20 disable
SM8053 I30 disable
SM8054 I40 disable
SM8055 I50 disable
SM8056 I60 disable
SM8057 I70 disable
SM8058 I80 disable
Description
When SM8016 turns ON, the time display is stopped.
At the edge from OFF to ON, the RTC is set to the nearest minute.
(When the second data is from 0 to 29, it is set to 0. When the
second data is from 30 to 59, it is set to 0 and the minute data is
incriminated by "1".)
When the data stored in special registers is outside the allowable
time setting range, this device turns ON.
OFF: Zero flag OFF
ON: Zero flag ON
OFF: Borrow flag OFF
ON: Borrow flag ON
OFF: Carry flag OFF
ON: Carry flag ON
SM8023 turns ON at the time of RTC access (reading/writing)
error occurrence.
OFF: Standard mode
ON: RAMP mode
OFF: Instruction execution not complete
ON: Instruction execution complete
OFF: No clear
ON: Non-latch memory all clear
OFF: No clear
ON: Latch memory all clear
OFF: Clear
ON: Hold
OFF: Normal operation
ON: All output disable
OFF: Normal operation
ON: Constant scan mode
OFF: Normal operation
ON: Transfer disable
Transfer from initial state is enabled in automatic operation mode
Pulse output is given in response to a start input
Set this in the last state of zero return mode
Set this when machine zero return is detected
Disables the 'all output reset' function when the operation mode is
changed
ON when SM8047 is ON and any state (S) is active
SD8040 to SD8047 are enabled when SM8047 is ON
ON when SM8049 is ON and any annunciator (F) is ON.
SD8049 is enabled when SM8049 is ON.
OFF: Interrupt enabled
ON: Interrupt disabled
OFF: Interrupt enabled
ON: Interrupt disabled
OFF: Interrupt enabled
ON: Interrupt disabled
OFF: Interrupt enabled
ON: Interrupt disabled
OFF: Interrupt enabled
ON: Interrupt disabled
OFF: Interrupt enabled
ON: Interrupt disabled
OFF: Interrupt enabled
ON: Interrupt disabled
OFF: Interrupt enabled
ON: Interrupt disabled
OFF: Interrupt enabled
ON: Interrupt disabled
R/W
R/W
R/W
R
R
R
R
R
R/W
R
R/W
R/W
R/W
R/W
R/W
R/W
R
R
R/W
R/W
R/W
R
R/W
R
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
APPX
Appendix 1 Special Relay List
A
341