Mitsubishi Electric FX5 User Manual page 421

Error Error name Error details and cause
code
363CH Axis 12 • The 32-bit range was exceeded when
positioning the unit of the positioning address was
address error converted.
• The 32-bit range was exceeded when
the unit of the zero-point address was
converted.
• The total transfer distance before and
after the interrupt of the DVIT/DDVIT
instruction or 1-speed positioning with
interruption exceeded 7FFFFFFFH. Or,
when the operation was started, the
positioning address was set to 0.
• Pulses of 7FFFFFFFH or greater are
needed to specify an absolute address.
3641H Axis 1 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3642H Axis 2 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3643H Axis 3 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3644H Axis 4 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3645H Axis 5 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3646H Axis 6 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3647H Axis 7 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3648H Axis 8 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3649H Axis 9 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
364AH Axis 10 • The 32-bit range was exceeded when
command speed the unit of the command speed was
error converted.
• When the positioning was started, the
command speed was set to 0.
Action
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
Detailed Diagnostic
information timing
Error location At END
information instruction
and system execution, at
configuration interrupt
information occurrence
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location
At instruction
information
execution
and system
configuration
information
APPX
419
Appendix 3 Error Code
A