Table of Contents
Advertisement
3. Basic Printing
This chapter describes the basic procedure for making prints.
Basic Procedure
Using the default settings, you can process masters and make prints in a single operation. This is called
"Auto Cycle".
1.
Make sure "
Ready" appears on the display.
If the machine has user codes set, enter your user code using the number keys, and then press [#].
2.
Make sure no previous settings remain.
If previous settings remain, press the [Clear Modes] key before entering your settings.
3.
Check the [Auto Cycle] key is lit.
4.
Place the originals.
5.
Make the necessary settings.
6.
Enter the required number of prints using the number keys.
Set a print quantity between 1 (minimum) and 9999 (maximum).
CVU042
59
Advertisement
Table of Contents
