Table of Contents
Advertisement
full: Configures the interface to operate in full duplex mode, so that the interface can receive and
transmit packets at the same time.
half: Configures the interface to operate in half duplex mode, so that the interface can only receive or
transmit packets at a given time. Copper ports operating at 1000 Mbps or 10 Gbps and fiber ports do
not support this keyword.
Examples
# Configure interface GigabitEthernet 1/0/1 to operate in full duplex mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] duplex full
eee enable
IMPORTANT:
Fiber ports do not support this command.
Use eee enable to enable EEE.
Use undo eee enable to restore the default.
Syntax
eee enable
undo eee enable
Default
EEE is disabled.
Views
Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
With the EEE function, a link-up port enters the low power state if it has not received any packet for a
certain period of time. The time period depends on the chip specifications and is not configurable.
When a packet arrives later, the port enters the normal state.
Examples
# Enable EEE on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] eee enable
flow-control
CAUTION:
Configuring generic flow control on an Ethernet interface will cause link-up and link-down events
before the interface finally stays up.
Use flow-control to enable TxRx mode generic flow control on an Ethernet interface.
17
Advertisement
Table of Contents
