Sysname - HP 6125XLG Command Reference Manual

Predefined user roles
network-admin
Parameters
time: Specifies a detection timer (in seconds) in the range of 1 to 300.
Usage guidelines
The device starts a detection timer when a port is shut down by a protocol. If the port is still down when
the detection timer expires, the device automatically brings up the port so the port status reflects the port's
actual physical status.
If you change the detection timer to T1 during port detection, the interval from when you change the timer
to the time when the protocol module shuts down the port is T. If T<T1, the down port will be recovered
after T1-T time. If T>=T1, the down port is recovered immediately. For example, if the detection timer is set
to 30 seconds and you change it to 10 seconds (T1=10) two seconds after the port is shut down (T=2),
this port will be recovered 8 seconds later. If the detection timer is set to 30 seconds and you change it
to 2 seconds ten seconds after the port is shut down, this port is recovered immediately.
Examples
# Set the detection timer to 100 seconds.
<Sysname> system-view
[Sysname] shutdown-interval 100

sysname

Use sysname to set the device name.
Use undo sysname to restore the default.
Syntax
sysname sysname
undo sysname
Default
The default device name is HP.
Views
System view
Predefined user roles
network-admin
Parameters
sysname: Specifies a name for the device, a string of 1 to 30 characters.
Usage guidelines
A device name identifies a device in a network and is used as the user view prompt at the CLI. For
example, if the device name is HP, the user view prompt is <HP>.
Examples
# Set the name of the device to R2000.
<Sysname> system-view
[Sysname] sysname R2000
180