Connecting The Maldi Ltq Xl System Forepumps To Line Power - Thermo Scientific LCQ Fleet Getting Started Manual

3
Connecting the MALDI LTQ XL System

Connecting the MALDI LTQ XL System Forepumps to Line Power

Connecting the MALDI LTQ XL System Forepumps to Line Power
Figure 6. Line power connections for the forepumps
Primary forepump
14 LTQ Series Getting Connected Guide
The MALDI LTQ XL system uses two forepumps.The primary forepump provides vacuum to
the LTQ XL MS detector. The secondary forepump provides vacuum to the MALDI sample
module.
As Figure 6 shows, you connect the primary forepump to the power entry panel of the
LTQ XL MS detector and the secondary forepump to the MALDI control module.
MALDI LTQ XL system
(right-side panel)
Power switch
I
0
MALDI control module
Laser
Power
Vacuum Pump
Power cable
Secondary forepump
(rear panel)
CAUTION
MODEL:MALDI Laser Control Module
SERIAL No:
Aux.
DISCONNECT
WARNING
Motors
Power
Finnigan MAT
PASS
Ground Continuity
and HPOT Tests
OFF ON Date:
By:
Power In
From LTQ Accessory Outlet ONLY!
Power cable
Power switch
I
0
Thermo Scientific