Connecting The Forepump To Line Power - Thermo Scientific LCQ Fleet Getting Started Manual

Connecting the Forepump to Line Power

Thermo Scientific
The forepump gets its line power from the MS detector. The power outlet for the forepump is
located on the power panel of the MS detector. As
on the lower-right side of the MS detector.
To connect the forepump to line power (the forepump outlet of the MS detector)
1. On the power panel, switch the Main Power circuit breaker to the Off position.
2. Connect the power cord plug of the forepump to the Mech. Pumps power receptacle on
the MS detector.
3. Turn on the power switch of the forepump.
Figure 3. View of the line power connection for the forepump (mechanical pump)
Electronic Normal
I
0
Forepump
1
Line Power, Vacuum System, Gases, and Ethernet Communication
Main power
circuit breaker
Peripheral Control
Start
In
Reset
+ -
Ethernet
100 Base T
Analog Input
Service Mode
Power switch
Connecting the Forepump to the LCQ Fleet or LXQ MS Detector
Figure 3 shows, the power panel is located
Mechanical pump
power receptacle
Power In
V 230 V
Hz 50/60
Main Power
10A
Mech. Pumps
On
A 5.5 MAX
Off
MS detector
(right side panel)
LTQ Series Getting Connected Guide 5