Siemens SISTORE AX9 250 User Manual page 69

Siemens Building Technologies
Fire Safety & Security Products
Fig. 73 Camera PTZ setup screen
NOTE
You will only be able to set up PTZ devices if the PTZ port is set to RS232 or RS485. You will not be
able to use a modem if you are using the RS232 port for PTZ control.
2. Highlight the box in the Product column for the PTZ camera you wish to
configure and press the
A list of PTZ devices appears.
3. Select your camera from the list and press the
You will need to connect the camera to the RS232 or RS485 connector on the
back of the DVR following the camera manufacturer's instructions.
Fig. 74 PTZ Device list
You can assign IDs to each camera by highlighting the box under the ID
heading and pressing the
4. Change the number by highlighting it and using the Up and Down arrow
buttons to increase and decrease the number.
The PTZ ID number can be set from 0 to 256.
5. Highlight the Setup... box and press the
The Port Setup window appears.
Fig. 75 Port Setup window
button.
button.
button.
button.
Configuration
69
03.2007