Installation and setup
Siemens Building Technologies
Fire Safety & Security Products
Do not place this equipment on an unstable cart, stand or table. The equipment
may fall, causing serious injury to a child or adult, and serious damage to the
equipment. Wall or shelf mounting should follow the manufacturer's instructions,
and should use a mounting kit approved by the manufacturer. Do not misplace
this equipment other than upright position. This equipment has an open frame
SMPS (Switching Mode Power Supply), which may cause a fire or electric shock
if anything is inserted into the unit through the ventilation holes on the side of the
This equipment and cart combination should be moved with care. Quick stops,
excessive force, and uneven surfaces may cause the equipment and cart
combination to overturn.
Never add any attachments and/or equipment without the approval of the
manufacturer as such additions may result in the risk of fire, electric shock or
other personal injury.
This installation should be made by a qualified service person and should
conform to all local codes.
Warning: Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
Cable damage due to mechanical load
When connecting the cables, do not apply tensile force and make sure not to
bend or damage them.
Overheating due to lack of ventilation
Do not block or cover ventilation openings.
Damage due to unsuitable mounting location
The environmental conditions recommended by the manufacturer must be
observed. See Section: 3: Technical data.
Elevated Operating Ambient Temperature
If installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than room ambient.
Therefore, consideration should be given to installing the equipment in an
environment compatible with the manufacturer's maximum rated ambient